Supergrip Grip Tape for Vaxee Mice: Sizing and Application
By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-10-31
Category: How-to Guides
A practical, step-by-step guide to sizing and applying Supergrip Grip Tape on Vaxee mice, with checkpoints to avoid common mistakes and get a secure, sweat-resistant grip.
Quick answer
Apply Supergrip Grip Tape to your Vaxee mouse by first cleaning the shell, then tracing and cutting pieces for the main grip points (left and right sides, and optionally the top). Press firmly for 30 seconds and let it set before gaming. This guide walks you through sizing and application with checkpoints to avoid common mistakes.
Why sizing matters on Vaxee shapes
Vaxee mice often have subtle curves and a coating that can affect adhesion. Pre-sizing each piece prevents overlaps that lift at the edges and ensures the tape sits flush on the sides without interfering with buttons or the scroll wheel.
When to skip the top piece
If you use a fingertip or claw grip and your palm rarely contacts the top shell, you can skip the top piece. Adding it may change the feel and add unnecessary thickness. Focus on the sides where your thumb and fingers rest.
Step-by-step application
- Clean the mouse shell: Wipe the areas where you plan to apply tape with a lint-free cloth and a small amount of isopropyl alcohol. Let it dry completely. Checkpoint: Any leftover oil or dust will weaken adhesion, so clean until the surface is completely dry.
- Trace and cut pieces: Place the tape over the side grip area and use a fine-tip marker to trace the outline, leaving a 1–2 mm margin. Cut with sharp scissors. Common mistake: Cutting too large causes overlaps; start slightly larger and trim after a test fit.
- Test-fit before peeling: Hold the cut piece against the mouse without removing the backing to check coverage and clearance around buttons and seams. Checkpoint: Ensure the tape does not cover any sensor or button gaps.
- Peel and apply: Peel a small corner of the backing and align the tape with the edge. Press down gradually while peeling the rest of the backing. Common mistake: Peeling the entire backing at once can cause the tape to stick to itself; go slowly.
- Press firmly: Use your thumb to press the tape firmly from the center outward for 30 seconds, especially along the edges. Checkpoint: Edges should be fully adhered; lift and re-press any loose corners.
- Let it set: Wait at least 10 minutes before gaming to allow the adhesive to bond fully. Takeaway: Avoid immediate heavy use to extend the tape's lifespan.
Product facts
- Supergrip Grip Tape for Vaxee Mouse Series: Developed and crafted in Japan, this grip tape is designed for professional athletes and absorbs sweat to enhance grip. The sweat-absorbing material helps maintain a secure hold during long sessions, reducing the need to readjust your grip.
Supergrip Grip Tape for Vaxee Mouse Series
