Superglide Type-S for TenZ Signature: Glass Feet Fit Guide

By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-10-31

Category: How-to Guides

Install Superglide Type-S glass feet on your TenZ Signature mouse with this step-by-step guide, including surface prep, alignment, and curing checks.

Quick answer

Replace your TenZ Signature’s stock feet with Superglide Type-S glass feet for a faster, smoother glide. Clean the mouse base thoroughly, align the new feet precisely, and let the adhesive cure fully before gaming.

Why Type-S glass feet change the feel

Superglide Type-S feet use a micro-surfaced texture that covers the entire foot, including the rounded edges. This design is optimized for high-tempo play where quick, consistent swipes matter more than control.

Compared to stock PTFE feet, glass feet reduce friction and break-in time, but they also demand a clean, flat mousepad surface. If your pad is worn or dirty, you may feel inconsistent glide.

When to skip this upgrade

If you rely on heavy control or often play on textured or hybrid pads, glass feet may feel too fast. Also, if your TenZ Signature is still under warranty and you want to keep it intact, removing stock feet could void coverage—check the terms first.

This guide assumes you have the correct Type-S variant for the TenZ Signature. Using feet designed for another model can cause fit issues or poor performance.

Step-by-step installation

Remove old feet: Use a plastic tool or your fingernail to lift the stock feet from the mouse base. Work slowly to avoid scratching the plastic. Common mistake: prying with a metal screwdriver, which can gouge the base and create uneven seating. Check that the base is free of deep scratches before moving on.
Clean the base: Wipe the foot recesses with isopropyl alcohol on a lint-free cloth, then let them dry completely. Common mistake: skipping this step leaves oil or adhesive residue that prevents proper bonding. The surface should look matte and feel completely dry before you apply new feet.
Test-fit before peeling: Place the new Superglide feet into the recesses without removing the backing to confirm alignment. The rounded edges should sit flush with the base. Common mistake: peeling the adhesive first and then struggling to reposition. If the feet overhang or don’t sit flat, double-check you have the correct TenZ Signature variant.
Apply and press: Peel the backing and set each foot into its recess, pressing firmly for 10–15 seconds. Avoid touching the adhesive side. Common mistake: pressing too lightly, which can leave air pockets. Run your finger around the edges to ensure no lip is raised.
Let adhesive cure: Wait at least 30 minutes before using the mouse, and avoid intense gaming for a few hours. Common mistake: testing glide immediately, which can shift the feet before the bond sets. After curing, lift the mouse and check that all feet are still perfectly seated.

Product facts

Superglide (Type-S) for TenZ Signature: Superglide (Type-S) for TenZ Signature features a micro-surfaced texture across the entire foot, including rounded edges. This full-surface texture is designed to deliver maximum speed and a smooth glide, which suits fast-paced aiming styles.
Superglide (Type-S) for TenZ Signature