Supergrip Un-cut Sheet: How to Cut Custom Grip Tape for Any Mouse
By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-11-05
Category: How-to Guides
Turn one Supergrip Un-cut Sheet into a precise, sweat-absorbing grip for any mouse. Follow these steps to template, cut, and apply without wasting material.
Quick answer
Use the Supergrip Un-cut Sheet to make a custom grip tape for any mouse by first creating a paper template of each grip zone, then cutting the sheet slightly inside your traced lines and applying it with light pressure. The sheet’s sweat-absorbing material gives you a precise fit without pre-cut limitations.
Why a template beats freehand cutting
Freehand cutting often leaves uneven edges that peel or feel rough. A paper template lets you test the shape on the mouse before you commit to the sheet. Because the Supergrip sheet is thin and durable, a slightly oversized template is easier to trim down than a piece cut too small.
Where to place grip tape for the biggest gain
Most players benefit from tape on the main left and right buttons, the sides where the thumb and ring finger rest, and sometimes the back hump. Start with one or two zones, test in-game, then expand. Avoid covering sensor lenses, seams, or button gaps that need to flex.
When not to use a custom sheet
If your mouse has complex curves or very small side buttons, a pre-cut kit may fit more cleanly. The Un-cut Sheet is best when you want full control over shape and coverage, or when pre-cut sets do not match your grip style.
Step-by-step: cut and apply custom grip tape
- Clean the mouse surface: Wipe the areas where you plan to apply tape with a lint-free cloth and a small amount of isopropyl alcohol. Let it dry completely. Skip this and dust or oil will weaken the adhesive; check that no residue remains before moving on.
- Make a paper template: Place a thin sheet of paper over the grip zone and gently press around the edges with a pencil or your fingernail to emboss the shape. Cut out the template and test-fit it on the mouse. Trim the template until it sits flat without overlapping buttons or seams; a common mistake is making it too large.
- Trace the template onto the Supergrip sheet: Lay the template on the backing side of the Un-cut Sheet and trace around it with a fine-tip pen. Leave a 1–2 mm margin on all sides for final trimming. Trace on the backing, not the grip side, to avoid ink transfer; double-check orientation before cutting.
- Cut the grip tape: Use sharp scissors or a craft knife to cut along your traced lines. Cut slightly inside the line for a snug fit, or outside for easier placement. Dull blades fray the edges; test the cut piece on the mouse before removing the backing.
- Apply and press: Peel the backing from one corner and press the tape onto the mouse, smoothing from the center outward to push out air bubbles. Apply firm pressure for 30 seconds. Do not stretch the tape during application; stretching can cause it to lift later.
- Trim and refine: If any edges overhang or feel rough, trim them with small scissors after application. Use a toothpick to press down edges around curves. Wait a few minutes before trimming so the adhesive can set; this reduces slipping.
Product facts
- Supergrip Un-cut Sheet: The Supergrip Un-cut Sheet is developed and crafted in Japan from a gauze bandage transformed into a thin, durable sheet. That thinness helps the tape conform to mouse curves without adding noticeable bulk.
Supergrip Un-cut Sheet - Supergrip Un-cut Sheet: The material is designed to absorb sweat from your hand and enhance grip performance. You get a more secure hold during long sessions, which is especially useful if your hands perspire.
