Superglide Type-S for JV-X: Fit Checks and Installation Steps
By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-11-03
Category: How-to Guides
A practical walkthrough for fitting Superglide Type-S glass feet to the JV-X, from checking your mouse version to seating the skates without bubbles or lift.
Quick answer
Use Superglide Type-S feet made for the JV-X, confirm your mouse matches that model, then clean the base and press each foot down evenly before you test glide. The main risks are trapped dust and uneven seating, not the glass surface itself.
Why the JV-X fit check comes before the peel
Superglide Type-S is sold as a model-specific fit, so the first job is confirming that your mouse is the JV-X and not a similarly named version. Once the adhesive is exposed, a mis-sized foot is hard to reposition cleanly.
This guide covers fit and installation only. If you are still deciding between glass and PTFE, compare contact feel and the surface you play on before committing to glass skates.
What the Type-S surface changes in practice
The Type-S surface is a micro-textured high-speed glide layer that covers the whole foot, including the rounded edges. That matters at the edges: a smooth, continuous surface gives a more consistent feel when the mouse tilts during fast swipes.
Faster glide also means less stopping friction. If you rely on friction to control micro-adjustments, expect to recalibrate your sensitivity or mouse control after the swap.
Installation steps for Superglide Type-S on the JV-X
- Confirm the model: Check the label or underside of your mouse and confirm it is the JV-X before opening the Superglide Type-S pack. Common mistake: assuming a similar model uses the same foot layout. If the model does not match, stop before removing any backing.
- Remove the old feet and clean the base: Peel off the existing skates and wipe the base with isopropyl alcohol, then let it dry fully. Common mistake: leaving adhesive residue or dust, which creates high spots under glass. The base should be dry and free of residue before any new foot goes on.
- Dry-fit each foot before peeling: Place each Superglide foot in its recess without removing the backing and check that it sits flush inside the edge. Common mistake: pressing down on a foot that overhangs the recess. A foot that rocks or overhangs will not seat flat after adhesion.
- Peel and press from the center outward: Expose the adhesive, set the foot in place, and press from the middle toward the rounded edges with steady thumb pressure. Common mistake: trapping an air bubble by pressing only at the edges. Work out any bubble before moving to the next foot.
- Let the adhesive settle before testing: Give the feet a short settling period on a clean, flat surface before heavy use, then test glide with slow figure-eights. Common mistake: immediately jumping into a fast session and shifting a foot that has not fully bonded. If a foot feels raised or catches, reseat it before playing.
Product facts
- Superglide (Type-S) for JV-X: Superglide (Type-S) for JV-X uses a micro-surfaced texture across the entire foot, including the rounded edges. The continuous surface is designed to keep glide consistent right to the edge of each foot rather than only in the center.
Superglide (Type-S) for JV-X
