Supergrip Grip Tape for Razer Mice: Fit, Sizing and Application
By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-11-02
Category: How-to Guides
Learn how to fit, size and apply Supergrip Grip Tape to your Razer mouse. Follow our step-by-step guide for a secure, sweat-absorbing grip that lasts.
Quick answer
Apply Supergrip Grip Tape to your Razer mouse by cleaning the surface, test-fitting the pre-cut pieces, and pressing them on with steady pressure. Work slowly and align edges before pressing down to avoid bubbles and misalignment.
Why surface prep matters more than tape choice
Even the best grip tape won't stick to a dirty or oily mouse. Razer mice often have textured side grips that trap sweat and dust, so cleaning with the included alcohol wipe is essential. Skip this step and you'll get peeling edges within days.
Also, avoid touching the adhesive side after cleaning—oils from your fingers reduce tackiness. Handle the pieces by their edges or use the provided tweezers if available.
Sizing: pre-cut vs. custom trimming
Supergrip Grip Tape for Razer Mouse Series comes with pre-cut pieces designed for common Razer shapes, but not every model is identical. Test-fit each piece before peeling the backing. If a piece overlaps buttons or seams, trim it with small scissors for a cleaner fit.
For Razer mice with unusual side button layouts, you may need to trim around the buttons. Always trim before applying—removing and repositioning stretched tape weakens the adhesive.
Common mistakes to avoid
Don't stretch the tape during application; it will slowly contract and lift at the edges. Also, avoid applying over curved areas without pressing firmly—Supergrip is thin but needs full contact to absorb sweat effectively. Finally, give the tape 10–15 minutes to set before intense gaming.
Step-by-step application for Razer mice
- Clean the mouse surface: Wipe the sides and buttons with the included alcohol wipe and let them dry completely. Common mistake: skipping drying time leaves moisture that prevents adhesion. Surface must be completely dry before applying tape.
- Test-fit the pre-cut pieces: Place each piece on the mouse without removing the backing to check alignment. Trim any excess with small scissors if needed. Common mistake: peeling the backing too early leads to misalignment. Always test-fit before exposing adhesive.
- Apply from the center outward: Peel the backing and press the piece down starting from the center, working outward to push out air bubbles. Use firm pressure for 10 seconds. Common mistake: pressing edges first traps air. Center-out application prevents bubbles.
- Press edges firmly: Run your thumb along all edges to ensure they seal completely. Pay extra attention to curved areas. Common mistake: lifting edges later if not pressed well. Edge sealing is critical for longevity.
- Let it set before gaming: Wait 10–15 minutes before heavy use to allow the adhesive to bond fully. Common mistake: immediate intense gaming can shift the tape. Short curing time improves durability.
Product facts
- Supergrip Grip Tape for Razer Mouse Series: Developed and crafted in Japan, this grip tape uses a proprietary process to transform gauze bandage into a thin, durable sheet that absorbs sweat. The sweat-absorbing material helps maintain grip during long sessions, especially on Razer mice with smooth or worn side grips.
Supergrip Grip Tape for Razer Mouse Series
