Superglide Type-S for Razer DeathAdder v3 Pro: White Fit Guide

By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-10-27

Category: How-to Guides

Learn how to install Superglide Type-S glass feet on your Razer DeathAdder v3 Pro in white. Step-by-step guidance with common mistakes and checkpoints.

Quick Answer

Yes, Superglide Type-S glass feet are designed to fit the Razer DeathAdder v3 Pro, and the white version matches the mouse's aesthetic. Follow the installation steps below for a secure, long-lasting fit.

Why Glass Feet for Your DeathAdder v3 Pro?

The Razer DeathAdder v3 Pro is a lightweight esports mouse that benefits from low-friction feet. Superglide Type-S uses aluminosilicate glass, which provides a smoother glide than standard PTFE feet and is more durable, so you won't need to replace them as often.

What to Check Before You Start

Before installing, ensure your mouse is clean and dry. The adhesive on Superglide feet is strong, but any dust or oil can prevent a secure bond. Also, verify that the feet are the correct Type-S variant for the DeathAdder v3 Pro; using the wrong type may cause fit issues.

Installation Steps

Clean the mouse bottom: Use a microfiber cloth and isopropyl alcohol to remove all dust, oil, and residue from the area where the feet will be placed. Let it dry completely. Check that the surface is completely dry before proceeding.
Remove the old feet: Carefully peel off the existing PTFE feet using a plastic spudger or your fingernail. Avoid using metal tools that could scratch the mouse base. If any adhesive remains, gently rub it off with a soft cloth and alcohol.
Align the new Superglide feet: Position the white Superglide Type-S feet over the corresponding slots on the DeathAdder v3 Pro. Ensure the shape matches exactly before pressing down. Double-check the alignment before pressing; once the adhesive bonds, repositioning is difficult.
Press firmly and evenly: Press each foot firmly from the center outward to push out any air bubbles and ensure a secure bond. Apply even pressure for about 30 seconds. Run your finger over the edges to confirm they are fully seated.
Wait before using: Allow the adhesive to cure for at least 30 minutes before using the mouse. This ensures the feet stay firmly attached during intense gaming sessions. Test the glide on a mousepad to confirm smooth movement.

Product Facts

Superglide Type-S Razer DeathAdder v3 Pro [White]: Made with super-strong aluminosilicate glass, providing a super-fast and super-smooth glide that feels like floating. This gives you an advantage in micro aiming and tracking, and the glass won't wear down quickly like conventional PTFE feet.
Superglide Type-S Razer DeathAdder v3 Pro [White]