How to Apply Supergrip Grip Tape on Sta-X Mouse

By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-10-29

Category: How-to Guides

Learn step-by-step how to apply Pulsar Supergrip Grip Tape on your Sta-X mouse for a secure, comfortable hold and improved control during intense gaming sessions.

Quick Answer

Clean the Sta-X shell, peel the pre-cut Supergrip pieces, align each piece carefully, and press firmly. This takes about 10 minutes and gives you a stable, sweat-resistant grip for long sessions.

Why the Sta-X Needs a Grip Tape Mod

The Pulsar Sta-X is a lightweight gaming mouse, which makes it easy to flick, but its smooth plastic can get slippery when your hands heat up. A grip tape mod adds texture exactly where your fingers and palm rest, so you can keep a consistent hold without squeezing harder.

Supergrip tape is tailored specifically for the Sta-X, so the pieces match the mouse's curves and button contours. That means no cutting or guesswork—just peel and apply. The main tradeoff is that grip tape is a consumable: it wears down over time, and you'll need to replace it when the texture flattens.

Step-by-Step Application

Clean and dry the mouse: Wipe the Sta-X shell with a microfiber cloth and a little isopropyl alcohol to remove oils and dust. Let it dry completely. Checkpoint: If the surface is damp or greasy, the tape won't stick evenly.
Peel one piece at a time: Remove the backing from a single grip piece. Avoid touching the adhesive side with your fingers. Checkpoint: Work with one piece at a time so the adhesive doesn't collect dust while you're positioning.
Align and press: Start from one edge and lay the piece down slowly, aligning it with the mouse's contours. Use a soft cloth or your thumb to press from the center outward, smoothing out air bubbles. Checkpoint: If you misalign, peel it off gently and reapply immediately—don't wait or the adhesive may lose tack.
Repeat for all pieces: Apply the remaining pieces to the side grips, buttons, and any other included areas. Press firmly along the edges to ensure they adhere. Checkpoint: Give the tape a few minutes to bond before using the mouse in a game.

Product Facts

Supergrip Grip Tape for Sta-X: The Pulsar Supergrip Grip Tape for Sta-X is designed specifically for the Sta-X model, providing a secure and comfortable surface for improved control. Because the pieces are pre-cut for the Sta-X, you get full coverage on the buttons and sides without the hassle of trimming or misalignment.
Supergrip Grip Tape for Sta-X