How to Install Superglide Type-C Feet on Xlite Series Mice

By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-10-29

Category: How-to Guides

Step-by-step guide to replacing mouse feet on Pulsar Xlite series with Superglide Type-C glass skates. Includes preparation, alignment tips, and common mistakes to avoid.

Quick answer

Remove the old mouse feet, clean the recess, then peel and press the Superglide Type-C glass skates into place. Take your time aligning the edge cutouts to avoid lifting.

Before you start: what makes Type-C different

Superglide Type-C feet are designed specifically for mice with a Type-C charging port, like the Pulsar Xlite series. The glass skates are slightly thicker than standard PTFE, so you must fully remove the old feet and adhesive residue to prevent a wobbly fit.

If your mouse has a removable magnetic top shell (common on Xlite models), detach it first for easier access to the feet.

Tools you’ll need

A clean, flat workspace with good lighting. You'll need a hairdryer or heat gun (low setting), a plastic spudger or guitar pick, isopropyl alcohol (70% or higher), a lint-free cloth, and tweezers for handling the glass skates.

Installation steps

Remove old mouse feet: Heat the old feet with a hairdryer for 20-30 seconds to soften the adhesive. Use a plastic spudger to gently lift the edge and peel off each foot. Avoid metal tools that can scratch the plastic base. Common mistake: pulling too fast can tear the foot and leave adhesive behind. Work slowly.
Clean the recess: Wipe the recess with isopropyl alcohol on a lint-free cloth to remove all adhesive residue and dust. Let it dry completely for 2-3 minutes. Any leftover glue will prevent the glass foot from sitting flush. Checkpoint: run a fingernail across the recess – it should feel smooth, not sticky.
Peel and align the Superglide Type-C foot: Peel the backing from the glass foot using tweezers, handling it by the edges only. Align it with the recess, paying attention to the cutout for the Type-C port. Lower it straight down – do not slide it into place. Common mistake: touching the adhesive side leaves oils that reduce stickiness. Use the tweezers.
Press firmly and evenly: Press the foot down with your thumb for 15-20 seconds, applying even pressure across the whole surface. Focus on the edges and corners to ensure full adhesion. Reattach the top shell if you removed it. Checkpoint: if an edge lifts, reheat gently with the hairdryer for 5 seconds and press again.
Let the adhesive cure: Wait 30 minutes before using the mouse to let the adhesive bond fully. Avoid pressing hard on the mouse or gaming during this time. The glide will feel slightly slower for the first few hours as the micro-texture breaks in. Final tip: after 24 hours the stopping power and smoothness will reach their intended performance.

Product facts

Superglide (Type-C) for Xlite Series: Superglide (Type-C) for Xlite Series features a new controllable speed surface with micro-surfaced texture covering the entire surface, including round edges. This texture maintains fast glide while adding stopping power, making it ideal for flick-heavy games where you need precise control after quick movements.
Superglide (Type-C) for Xlite Series