Supergrip Grip Tape for X2A: Sizing and Application Tips

By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-11-03

Category: Tips & Care

Get a secure, sweat-resistant hold on your Pulsar X2A. Follow these sizing and application steps for Supergrip Grip Tape, plus care tips to keep the grip working.

Quick answer

For a reliable hold on your X2A, apply Supergrip Grip Tape after cleaning the shell with alcohol, trim pieces to cover only the contact zones, and press firmly from the center outward. Re-seat any edge that lifts before you start gaming.

Why sizing matters more on the X2A

The X2A has a compact, symmetrical shape, so grip tape that wraps too far around the sides can interfere with your palm or fingertips during claw and fingertip grips. Measure the flat contact areas first, then cut slightly inside those lines.

Supergrip is a thin sheet, so it adds minimal bulk, but overlapping pieces or excess material near the seams can still create a ridge. Keep each piece separate and avoid stretching the tape during application.

When to replace instead of reapply

If the tape has lost its tack or the edges curl after repeated cleaning, replace it rather than trying to reactivate the adhesive. Supergrip is designed to absorb sweat, and once the surface is saturated or contaminated with skin oils, its grip performance drops.

For everyday care, wipe the tape with a lightly damp cloth and let it air-dry fully before use. Avoid alcohol or harsh cleaners on the tape itself, as they can degrade the material.

Step-by-step application for X2A

Clean the mouse shell: Wipe the X2A’s main buttons and side grips with isopropyl alcohol and let them dry completely. Common mistake: skipping this step leaves oils that prevent the adhesive from bonding. Check that no lint remains before moving on.
Plan your piece placement: Decide where your thumb, ring finger, and pinky rest. Cut pieces to cover only those zones, leaving a 1–2 mm margin from buttons and seams. Common mistake: covering the entire side and interfering with your grip. Test the fit with the backing still on before peeling.
Trim and test-fit: Use sharp scissors to cut the tape. For curved areas, make small relief cuts rather than stretching the material. Common mistake: cutting pieces too large and overlapping edges. Dry-fit each piece and adjust before removing adhesive backing.
Apply from the center out: Peel a small section of backing, align the piece, and press from the center outward to push out air bubbles. Common mistake: pressing from one edge traps air and causes lifting. Work slowly and keep the tape flat against the shell.
Burnish the edges: Rub the edges firmly with your thumb or a soft cloth for 10–15 seconds. Common mistake: rushing this step leaves edges that catch on your palm. Re-press any edge that lifts immediately.
Let it set before gaming: Wait at least 10–15 minutes before heavy use so the adhesive can bond. Common mistake: gaming immediately and shifting the tape. Check adhesion again after your first session and press down any loose corners.

Product facts

Supergrip Grip Tape for X2A: Developed and crafted in Japan, this material is designed for professional athletes and absorbs sweat to enhance grip. The sweat-absorbing sheet helps maintain control during long sessions, so sizing it to your main contact points keeps that benefit where you need it.
Supergrip Grip Tape for X2A