Install Superglide 1 Feet on Xtrfy MZ1 Wireless
By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-10-24
Category: How-to Guides
Step-by-step guide to installing Superglide 1 glass mouse feet on your Xtrfy MZ1 Wireless. Learn the process, common mistakes, and how to get a perfect floating glide.
Quick answer
To install Superglide 1 feet on your Xtrfy MZ1 Wireless, carefully remove the old PTFE skates, clean the recesses, peel and stick the glass skates, then press firmly for 30 seconds. Avoid touching the adhesive or reusing old feet.
Why glass skates need a different installation approach
Glass mouse feet like the Superglide 1 are rigid and much thinner than PTFE skates. This means the adhesive layer must bond perfectly to a clean, flat surface. Any dust, oil, or leftover glue will prevent the skate from sitting flush, causing wobble or reduced glide.
Unlike PTFE feet that you can sometimes re-stick, glass skates are a one-shot install. Once the adhesive touches the mouse, repositioning is nearly impossible without damaging the skate or the adhesive bond.
Installation steps for Superglide 1 on Xtrfy MZ1 Wireless
- Remove the old PTFE feet: Use a plastic spudger or a hairdryer on low heat to soften the adhesive, then gently lift the old skates from the edges. Do not use a metal tool that could scratch the plastic recess. If you leave adhesive residue, the glass skate will not sit flat.
- Clean the recesses thoroughly: Wipe the recess with isopropyl alcohol (70% or higher) on a lint-free cloth. Let it dry completely for 2 minutes. Do not use water, soap, or paper towels that leave fibers. Even a tiny dust speck can create a bump under the glass.
- Align and stick the glass skate: Hold the Superglide 1 by its edges, remove the backing, and lower it straight into the recess without touching the adhesive. Press from the center outward to push out air. Once the adhesive touches the mouse, you cannot slide it into position — alignment must be perfect on the first try.
- Apply firm pressure for 30 seconds: Use your thumb to press each skate firmly for at least 30 seconds. Apply even pressure over the entire surface, especially the edges. Wait 24 hours before heavy gaming use to let the bond cure fully. Skipping the curing time can cause the skate to peel off during fast swipes.
Product facts
- Superglide 1 for Xtrfy MZ1 Wireless: Superglide 1 is made with super-strong aluminosilicate glass for a super-fast, super-smooth feel that won't wear fast like conventional PTFE feet. Because the glass is rigid and permanent, proper installation is critical to avoid air bubbles or uneven glide that would ruin the floating sensation.
Superglide 1 for Xtrfy MZ1 Wireless
