Superglide Type-C for X3 Series: Glass Feet Fit and Install Steps

By Official Pulsar Gaming Gears - The Best Gaming Gears In the ... | Published: 2026-11-05

Category: Recensioni prodotti

A step-by-step guide to installing Superglide Type-C glass feet on your Pulsar X3 mouse, including fit checks, surface prep, and common mistakes to avoid.

Quick answer

To install Superglide Type-C glass feet on your X3 Series mouse, first confirm you have the Type-C variant for X3, then clean the stock feet area thoroughly, align the new feet precisely, and press firmly for 30 seconds. Avoid removing and repositioning once the adhesive contacts the surface.

Why the Type-C surface changes your glide expectations

Superglide Type-C for X3 Series uses a micro-surfaced texture across the entire foot, including the rounded edges. This design maintains fast speed while adding stopping power, so you may notice a more controlled feel compared to older glass feet. That control can help in flick-heavy games, but it also means you should test your sensitivity after installation rather than assuming the same settings will feel identical.

When glass feet are not the right upgrade

If you often play on soft or uneven mousepads, glass feet may feel too fast or inconsistent because they rely on a clean, flat surface for uniform glide. Also, if you prefer a heavy, damped feel, the Type-C's controllable speed may still be quicker than you like. In those cases, stick with stock PTFE feet or a slower aftermarket option.

Installation steps for Superglide Type-C on X3 Series

Verify the fit: Check that your package is labeled Type-C for X3 Series. The feet are shaped specifically for the X3's skate recesses. Do not force a different model's feet onto the X3; misalignment will cause uneven glide. Test-fit the feet in the recesses before removing any adhesive backing.
Remove old feet and clean: Peel off the stock feet slowly, then use isopropyl alcohol and a lint-free cloth to remove all adhesive residue from the recesses. Let the surface dry completely. A common mistake is skipping the alcohol wipe, which leaves oils that weaken the new adhesive. Run a fingernail across the recess to feel for any leftover residue before proceeding.
Align and place: Peel the backing from one foot at a time and lower it into the recess, using the edges as a guide. Press down firmly for 30 seconds. Avoid lifting and repositioning; once the adhesive touches the surface, it loses tack. If a foot is slightly off, remove it completely and use a fresh spare rather than trying to shift it.
Press and cure: After all feet are placed, turn the mouse upside down and press each foot against a hard, flat surface for another 30 seconds. Let the mouse sit for 10–15 minutes before use to let the adhesive fully bond. Using the mouse immediately can shift the feet. Set a timer for 15 minutes and avoid handling the mouse during that time.
Test and adjust: Place the mouse on your pad and make slow circles to check for wobble or scratching. If you feel inconsistency, re-check that each foot is fully seated. A common mistake is assuming glass feet need no break-in; give them a few hours of play to settle. If wobble persists, remove the foot and check for debris trapped underneath.

Product facts

Superglide (Type-C) for X3 Series: Superglide 2 (Type-C) features a micro-surfaced texture that covers the entire surface, including the round edges. This full-surface texture means you get consistent glide and stopping power even if your mouse tilts slightly during play, unlike feet with only a flat top surface.
Superglide (Type-C) for X3 Series